304 Stainless Threaded Stud Double-Ended Stud

304 Stainless Threaded Stud Double-Ended Stud

Product Overview This is a double-ended stud machined from AISI 304 stainless steel, threaded at both ends with a plain shank between them. One end screws into a tapped hole in the equipment or flange, while the other takes a nut to clamp the joint. That layout puts the load into the thread...
Send Inquiry
Description

Handan Zhongpin Fasteners Manufacturing Co., Ltd. is one of the most reliable manufacturers and suppliers of 304 stainless threaded stud double-ended stud in China. Welcome to buy bulk high quality 304 stainless threaded stud double-ended stud made in China here from our factory. If you have any enquiry about cooperation, please feel free to email us.

 

Product Overview

 

This is a double-ended stud machined from AISI 304 stainless steel, threaded at both ends with a plain shank between them. One end screws into a tapped hole in the equipment or flange, while the other takes a nut to clamp the joint. That layout puts the load into the thread rather than into a bolt head, which is useful where space is tight or where the joint is opened repeatedly. The 304 grade gives corrosion resistance without a coating, so there is no zinc layer to wear off during assembly.

product-698-524

01

AISI 304 (A2) stainless steel, supplied in A2-70 condition, with a passivated surface.

 

02

Threads on both ends, equal or unequal lengths to your drawing, with a plain shank in between.

 

03

Metric coarse pitch as standard, fine pitch available for adjustment-sensitive joints.

 

04

No plating step, so no risk of coating build-up inside the thread.

 

 

Application Scenarios

 

  • Equipment mounting

    Used to locate motors, pumps and gearboxes on base plates. The stud stays in the tapped hole during maintenance, so the housing can be lifted off without the fastener falling out.

  • Pipe connections.

    Used on flanged pipework in water treatment and food processing lines. The stud passes through both flanges and is tightened from the free end, giving even clamping around the gasket.

     
  • Machinery assembly

    . Used in fixtures, jigs and machine frames where one side of the joint is a threaded boss rather than a through hole. The plain shank also acts as a locating shoulder.

 

Precautions

product-566-324

Do not use carbon steel taps, dies or wire brushes on these studs; iron particles left on the surface will rust and stain the 304. Do not treat 304 as a substitute for 316 in chloride service. When a joint will be opened often, replace the nuts rather than reusing work-hardened ones. Store the studs dry and keep them separate from carbon steel parts before installation.

 

Related Products

 

 304 hex nuts, 304 flat and spring washers, DIN 938 / DIN 939 studs, 316 stainless studs for coastal use, PTFE-coated studs for chemical service.

 

Hot Tags: 304 stainless threaded stud double-ended stud, China 304 stainless threaded stud double-ended stud manufacturers, suppliers, factory, cut to length threaded rod

Send Inquiry